Jeep® Wrangler Replacement Rear Crossmember

Trashed that thin piece of stamped steel that is called a frame cross member on your Jeep?  Need something to beef up your frame for that heavy duty bumper and tire carrier?  This is a 3/16" thick steel cross member re-inforcement kit for the rear crossmember on the frame of a Jeep.  Note:this is not a "replacement" crossmember and will not support the gas tank without modification.

It is designed to beef-up your existing rear frame member AND body mounts. It can also  be used as a hi clearance bumper by itself or a re-inforcement under a rear bumper.

FEATURES:

• C channel design fits over and under frame.
• Laser cut and CNC formed into shape for a perfect fit.
• Allows you to repair damaged rear cross member.
• Allows you to beef up rear frame section.
• Can be installed under an existing rear bumper.(some modification may be necessary)
• Can be used by itself as a bumper for a better departure angle.
• Bolt-on design.
• Includes Grade 8 mounting hardware.
• Shipped to you un-painted.

• (1) Full width laser cut and bent rear plate 
• (2) Outboard rear frame brackets (can not be used on leaf spring vehicles)
• (1) Grade 8, 7/16-20 Hardware kit

IMPORTANT NOTES:

• Requires drilling additional holes in the rear cross member to properly mount it on your Jeep. 


• For proper mounting, it requires removing the fuel tank to drill and access center bolts.
• Will NOT work on CJ's.
• If this product is being used under a aftermarket rear bumper to beef up or re-inforce the rear cross member, you may have to cut off and re-weld the lower tabs on the rear bumper (if your bumper has these)