View detailed images (2)

This is the GenRight RBB-1001, a 3/16" thick steel cross member re-inforcement kit for the rear crossmember on the frame of a Jeep.

It is designed to beef-up your existing rear frame member AND body mounts. It can also be used as a hi clearance bumper by itself or a re-inforcement under a rear bumper.

As you can see in the pictures, you remove the rear most body mounts and install the plate then slip them back in place.

FEATURES:

• C channel design fits over and under frame.
• Laser cut and CNC formed into shape for a perfect fit.
• Allows you to repair or replace damaged rear cross members & body mounts (needed on LJ's).
• Allows you to beef up rear frame section.
• Can be installed under an existing rear bumper.
• Can be used by itself as a bumper for a better departure angle.
• Bolt-on design.
• Includes Grade 8 mounting hardware.
• Shipped to you un-painted.

This kit includes:

• (1) Full width laser cut and bent rear plate (RBB-1000)
• (2) Outboard rear frame brackets (can not be used on leaf spring vehicles)
• (1) Grade 8, 7/16-20 Hardware kit

IMPORTANT NOTES:

• Requires drilling additional holes in the rear cross member to properly mount it on your Jeep. 
• Includes hardware.
• Optional internal "backing plate" is recommended and available.
• For proper mounting, it requires removing the fuel tank to drill and access center bolts.
• Will NOT work on CJ's.
• If this product is being used under a aftermarket rear bumper to beef up or re-inforce the rear cross member, you may have to cut off and re-weld the lower tabs on the rear bumper (if your bumper has these).